Efficient Networks 107-0001-000 manual Remote setatmnsap, Remote restart remotename

Chapter 6: Remote Commands	Efficient Networks® Router family
	Command Line Interface Guide

remote restart

Stops the current active session and starts a new active session for a remote.

Certain configuration changes for a remote become effective only after the remote is restarted or the router is rebooted. Remember to save the changes before the restart or reboot.

NOTE:

Use restart instead of reboot whenever possible. A restart does not affect other interfaces, allowing their traffic to continue. For example, using restart, you can add an IP route without killing voice traffic.

To restart an Ethernet interface, use the eth restart command.

Mgmt Class

Network (R/W)

Input Format

remote restart <remotename>

Parameters

<remotename>a Name of the remote router.

aASCII string

Response

Command prompt.

remote setatmnsap

RFC1577 (Classical IP over ATM) specifies a mechanism to map an ATM Name (called an NSAP) to a PVC. NSAP’s are normally not needed, but if they are used, they have a syntax defined by using either the ATM or E164 encodings. By convention, octets 2-7 contain a unique identifier for the router, such as a MAC address.

In the command remote setATMnsap, the complete 20 octets of the NSAP are specified. If Partial mode is selected, the router substitutes the MAC address of the router for octets 2-7. In Full mode, no change is made to the NSAP.

To see an ATM NSAP that has been set, use the remote list command.

Page 6-40 Efficient Networks®