Omron CS1W-DRM21, CJ1W-DRM21 operation manual List of Usage Methods by Purpose

List of Usage Methods by Purpose			Section 1-7
	Situation	Action	Page
Operation	Stopping remote I/O communica-	Stop communications using the Configurator or the	62
	tions with all Slaves	Remote I/O Communications Stop Switch in the
		allocated CIO Area words.
	Using a scan list in remote I/O	Turn ON the Scan List Enable Switch in the allo-	61
	communications (fixed alloca-	cated CIO Area words.
	tions)
	Enabling a scan list in remote I/O	Set the allocation areas using the allocated DM	64
	communications (user-set alloca-	Area words, and turn ON the user-set allocations
	tions by allocated DM Area	user setting switch for the allocated CIO Area
	words)	words.
	Changing the communications	Turn ON the Scan List Clear Switch for the allo-	100
	system configuration	cated CIO Area words, and turn the Scan List
		Enable Switch back ON after you change the com-
		munications system.
	Checking master I/O allocation	Monitor the Master Status 2 status codes in the	75
	status (fixed allocations, user-set	allocated CIO Area words from a Programming
	allocations by allocated DM Area	Device.
	words, user-set allocations by the
	Configurator)
	Checking to see if all slaves are	Check the Registered Slave Table in the allocated	78
	registered in the scan list	CIO Area words.
	Checking to see if all slaves are	Check the Normal Slave Table in the allocated CIO	79
	performing remote I/O communi-	Area words.
	cations properly
	Checking to see if there is an	Check the error history (registration yes/no) in the	73
	error history in the DeviceNet	allocated CIO Area words from a Programming
	Unit	Device.
	Monitoring the error history in the	Execute the device monitor function from the Con-	DeviceNet Con-
	DeviceNet Unit	figurator (Error History Tab).	figurator Opera-
			tion Manual
	Monitoring status of the	Execute the device monitor function from the Con-
	DeviceNet Unit	figurator (Status and Unit Status Tabs).
	Checking the current communi-	Execute the device monitor function from the Con-
	cations cycle time	figurator (Current Communications Cycle Time
		Tab).
	Adjusting the communications	Execute the device parameter edit function from
	cycle time	the Configurator (Communications Cycle Time
		Tab).
	Saving all parameters, like scan	Save the network configuration from the Configura-
	list data, for masters and slaves	tor.
	on the network
	Replacing a DeviceNet Unit	1. Insert a Memory Card in the CPU Unit and turn	226, 247
		ON the Unit Setup File Backup Switch in the
		allocated CIO Area words.
		2. Replace the DeviceNet Unit.
		3. Turn ON the Unit Setup File List Switch in the
		allocated CIO Area words.
		4. Turn ON Scan List Clear Switch in the allocated
		CIO Area words.
		5. Make sure the slave is connected, and then turn
		ON the Scan List Enable Switch.

43