Omron CJ1W-DRM21, CS1W-DRM21 Scan Slave Unit, List Func Oper Sta Tion Ating Tus Mode

Allocated CIO Area Words										Section 3-2
Bit	Name	Status	Con-	Unit operation				Operation			Default
			trolled by					conditions			setting
								CPU		Slave
								Unit		func-
							oper-			tion
							ating
							mode
11	Slave User	OFF→	User	Reads setup data from the Slave User Allocations Setup			Pro-			Dis-	Slave
	Alloca-	ON		Table in the DM Area and registers slave user-set alloca-			gram			abled	Fixed
	tions			tions.			mode				Alloca-
	Switch			Once registered, the Unit will operate with slave user-set							tion set-
											ting 1
				allocations regardless of whether the power is turned
											enabled
				OFF and back ON again until slave communications are
				disabled (i.e., until Slave Disable Switch (word n+1, bit
				07) is turned ON).
				Slave communications must be disabled before this
				switch is turned ON.
				Note After the switch is turned ON, turn the Slave
				Enable Switch (word n+1, bit 06) ON to enable
				user-set allocations.
		OFF	Unit	Returns to OFF at the start of operation for slave user-
				set allocations.
				Note The Slave Function Enable/Stop Failed Flag
				(word n+14, bit 08) in Unit Status 2 will turn ON if
				there is a setting error.
12	Slave	OFF→	User	Sends COS IN data to the master.			---		---		None
	COS Send	ON
	Switch
		OFF	Unit	Returns to OFF after transmission is completed regard-
				less of whether it was completed normally or in error.
13	Reserved	---	---	---			---		---		---
	by system
Bit	Name	Status	Con-	Unit operation	Operation conditions						Default
			trolled by								setting
					CPU	Mas-		Scan		Slave
					Unit	ter		list		func-
					oper-	func		sta-		tion
					ating	tion		tus
					mode
14	Unit Setup	OFF→	User	Reads Unit settings (scan list, communica-	Pro-	---		---		---	None
	File	ON		tions cycle time settings, etc.) from the file	gram
	Restore			on a Memory Card in the CPU Unit and	mode
	Switch			writes the data as Unit settings. See7-2
				Memory Card Backup Functions for details.
				(The Unit automatically restarts.)
				Note After the file data is read, the Unit
				automatically restarts with the new
				data.
		OFF	Unit	Returns to OFF when the Unit restarts if
				the data is read properly.
				Note The File Read/Write Error Flag
				(word n+11, bit 08) in Unit Status 2
				will turn ON if there is a setup data
				error or a file read error.

68