Omron CS1W-DRM21, CJ1W-DRM21 operation manual Tions Flag for Ter OUT 2/IN

Allocated CIO Area Words				Section 3-2
Bit	Name	Status	Controlled	Unit operation
			by
11	COS Send	ON	Unit	Indicates that an attempt was made to send COS to a Master using the
	Failed Flag			Slave COS send switch (Slave COS Send Switch in n+1) in Software
				Switches 2, but the transmission failed.
				The following may cause the failure of COS signal transmission.
				• A COS connection was not established with a master.
				• Bus OFF error occurred.
				• A network power error occurred.
				• A send timeout occurred.
				Once this bit turns ON, it will remain ON until the operation is successfully
				completed.
		OFF	Unit	Indicates that the error has not occurred. The bit turns OFF when COS is
				successfully sent.
12	Connection	ON	Unit	Indicates that an I/O connection has been established for OUT 2/IN 2.
	2 Estab-			This bit turns ON even if valid I/O data has not been exchanged.
	lished Flag
		OFF	Unit	Indicates that an I/O connection has not been established for OUT 2/IN 2.
13	Connection	ON	Unit	Indicates that an I/O connection has been established for OUT 1/IN 1.
	1 Estab-			This bit turns ON even if valid I/O data has not been exchanged.
	lished Flag
		OFF	Unit	Indicates that an I/O connection has not been established for OUT 1/IN 1.
14	Remote I/O	ON	Unit	Indicates that an I/O connection has been established for OUT 2/IN 2 and
	Communica-			the slave is conducting normal remote I/O communications with the mas-
	tions Flag for			ter.
	OUT 2/IN 2
		OFF	Unit	Indicates that an I/O connection has been established for OUT 2/IN 2 and
				the slave is not conducting normal remote I/O communications with the
				master.
				Usage example: When writing the ladder program for slave remote I/O
				communications, used a NO input conditions for this bit to control I/O pro-
				cessing with the master.
15	Remote I/O	ON	Unit	Indicates that an I/O connection has been established for OUT 1/IN 1 and
	Communica-			the Slave is conducting normal remote I/O communications with the Mas-
	tions Flag for			ter.
	OUT 1/IN 1
		OFF	Unit	Indicates that an I/O connection has been established for OUT 1/IN 1 and
				the slave is not conducting normal remote I/O communications with the
				master.
				Usage example: When writing the ladder program for slave remote I/O
				communications, used a NO input conditions for this bit to control I/O pro-
				cessing with the master.

77