Siemens AC75 manual Password length of CM 8 digits, Atspwd=Cm

AC75 AT Command Set

5.7 AT^SPWD

s

Parameter Description

<facility>(str)

“CM“	Password used as Customer Mastercode for Customer SIM Lock.
	Defining the "CM" password allows the application manufacturer to set a Cus-
	tomer SIM Lock by activating a Network Personalization ("PN") with the
	AT^SCSL command. The "CM" password is mandatory for each operation with
	AT^SCSL.
	<password length> of "CM": 8 digits.
	To delete the "CM" password use the following syntax: AT^SPWD=<facil-
	ity>,<old password>. Please note that this action will delete all personali-
	sation data programmed by the manufacturer with AT^SCSL (including the
	operator list).

A description of all other passwords commonly supported by AT+CPWD and AT^SPWD can be found in Section 5.6, AT+CPWD. The "CM" password cannot be edited with AT+CPWD.

Notes

•When changing the PIN2 (<facility>="P2") it is recommended to check the new state of PIN2 using the

AT+CPIN2 command.

•In the airplane mode the write command version for the network related <facility> (AO, OI, OX, AI, IR, AB, AG and AC) is not supported. For remaining facilities the command is fully functional then.

Examples

EXAMPLE 1

To specify the "CM" password required as Customer Mastercode for the Customer SIM Lock:

	AT^SPWD="CM"	Check if the Customer Mastercode was already set.
	ERROR	No, it was not.
	AT^SPWD="CM", ,"12345678"	Specify a new Customer Mastercode (where <old
		password> is omitted and <new	pass-
		word>"12345678" = new Customer Mastercode)
	OK	The Customer Mastercode has been set to
		"12345678".
	AT^SPWD="CM"	Checking again.
	OK	Yes, it is active now.
EXAMPLE 2
	To change the Customer Mastercode:
	AT^SPWD="CM","12345678","44444444"	(where "12345678" = old Customer Mastercode, and
		"44444444" = new Customer Mastercode).
	OK	The Customer Mastercode has been changed from
		"12345678" to "44444444".
EXAMPLE 3
	To delete the Customer Mastercode:
	AT^SPWD="CM","44444444"	Delete the Customer Mastercode by omitting <new
		password> and entering only the <old	pass-
		word> "44444444".
	OK	The Customer Mastercode as well as all personali-
		sation data programmed by the manufacturer with
		AT^SCSL were deleted.

AC75_ATC_V01.002	Page 145 of 569	10/30/06
Confidential / Released