AC75 AT Command Set

20.9 AT^SSCNT

s

20.9AT^SSCNT Start and Stop Pulse Counter

The AT^SSCNT write command serves to read, start, restart and stop the pulse counter.

Syntax

Test Command

AT^SSCNT=?

Response(s)

^SSCNT:(list of supported <action>s)

OK

Read Command

AT^SSCNT?

Response(s)

^SSCNT: <action>

OK

If an error occurs:

ERROR

+CME ERROR: <err>

Write Command

AT^SSCNT=<action>

Response(s)

If <action>=0 or 1:

OK

If <action>=2 or 3:

OK

"^SSCNT" URC with parameter <pulse> If an error occurs:

ERROR

+CME ERROR: <err>

Reference(s)

SIEMENS

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

-

+

+

+

+

+

+

-

+

-

Unsolicited Result Code

^SSCNT: <pulse>

The URC applies only to the Start-Stop mode set with AT^SCCNT, parameter <mode>=0. It is delivered once the pulse counter result was requested with <action>=2 or the pulse counter was stopped with <action>=3. The URC indicates the number of pulses counted.

Parameter Description

<action>(num)

This parameter can only be used after configuring the pulse counter with AT^SCCNT. The <action> types 0, 1 and 2 apply only to the Start-Stop counter mode set with AT^SCCNT.

0

Reset and start pulse counter from 0.

1

Restart pulse counter and continue counting from the <pulse> value of the

 

last run.

2

Read out current <pulse> value.

AC75_ATC_V01.002

Page 519 of 569

10/30/06

Confidential / Released

 

 

Page 519
Image 519
Siemens AC75 manual Atsscnt Start and Stop Pulse Counter, Atsscnt=?, Atsscnt?