Siemens AC75 manual Using Atspbg without RealLocReq, Using Atspbg with RealLocReq, AT+CPBR=27

AC75 AT Command Set

17.10 AT^SPBG

s

<tlength>(num)

Maximum length of <text> assigned to the telephone number. The value indicated by the test command is given in octets. If the <text> string is given in GSM characters, each character corresponds to one octet. If the <text> string is given in UCS2, the maximum number of characters depends on the coding scheme used for the alpha field of the SIM according to GSM 11.11, Annex B [24]. In the worst case the number of UCS2 char- acters is at least one less than half the number of GSM characters.

Notes

•The command can be used for the phonebooks "SM", "FD", "ME" (cf. AT+CPBS).

•Users should be aware that when using this AT command quickly after SIM PIN authentication the SIM data may not yet be accessible, resulting in a short delay before the requested AT command response is returned. See Section 23.1, Restricted access to SIM data after SIM PIN authentication for further detail.

Examples

EXAMPLE 1
	Using AT^SPBG without <RealLocReq>:
	AT^SPBG=?	First run the AT^SPBG test command to find out the
		range of entries stored in the current phonebook.
	^SPBG: (1-33),20,17	TA returns the range, where 33 is the number of
		entries stored in the current phonebook.
	AT^SPBG=1,33	Now, enter the write command. To obtain best
	^SPBG:1,"+999999",145,"Arthur"	results it is recommended to query the full range of
	^SPBG:2,"+777777",145,"Bill"	entries. TA returns phonebook entries in alphabetical
	^SPBG:3,"+888888",145,"Charlie"	order.
	......................

The numbers at the beginning of each line are not the memory locations in the phonebook, but only serial numbers assigned to the entries' positions in the alphabetical list.

EXAMPLE 2
	Using AT^SPBG with <RealLocReq>:
	AT^SPBG=?	First run the AT^SPBG test command to find out the
		range of entries stored in the current phonebook.
	^SPBG: (1-33),20,17	TA returns the range, where 33 is the number of
		entries stored in the current phonebook.
	AT^SPBG=1,33,1	Now, enter the write command including parameter
	^SPBG:1,"+999999",145,"Arthur",27	<RealLocReq>=1 to get the actual location num-
	^SPBG:2,"+777777",145,"Bill",6	bers.
	^SPBG:3,"+888888",145,"Charlie",15
	......................

The numbers at the end of each line are the memory locations in the phonebook and can be used for dialing or editing phonebook entries:

AT+CPBR=27	Read out phonebook location 27.
+CPBR: 27,"+999999",145,"Arthur"	This entry can be edited with AT+CPBW or used for
	dialing with ATD><mem><n>.

AC75_ATC_V01.002	Page 451 of 569	10/30/06
Confidential / Released