Siemens AC75 manual Bmnum

AC75 AT Command Set

13.17 AT+CSMS

s

<bm>(num)

Broadcast Type Messages:
0	Type not supported
1	Type supported

Notes

•If CSMS mode is switched from Phase 2+ to Phase 2 and one or more AT+CNMI Parameter are Phase 2+ specific a '+CMS ERROR: unknown error' will appear. It is recommended to switch the AT+CNMI Parameters to Phase 2 specific values before entering Phase 2.

•Phase 2+ (<service>=1) must be set before the following features can be used:

-Configuring procedures for indicating received short messages with the AT+CNMI parameters <mt>=2 or

<mt>=3 and <ds>=1.

-Acknowledging incoming short messages with AT+CNMA.

-Receiving Status Reports and acknowledging them with AT+CNMA.

AC75_ATC_V01.002	Page 389 of 569	10/30/06
Confidential / Released