AC75 AT Command Set

10.1 AT^SICS

s

“authMode“

Authentication mode.

 

For supported values of <conParmValue> refer to <conParmValue-auth-

 

Mode>.

“fnur“

Fixed Network User Rate.

 

For supported values of <conParmValue> refer to <conParmValue-fnur>.

“dns1“

Primary DNS server address (IP address in dotted-four-byte format).

 

This value determines whether to use the DNS server addresses dynamically

 

assigned by the network or a specific DNS server address given by the user.

 

"dns1" = "0.0.0.0" (default) means that the CSD or GPRS connection profile

 

uses dynamic DNS assignment. Any other address means that the Primary

 

DNS is manually set.

 

The default value applies automatically if no other address is set. Note that the

 

AT^SICS read command only returns a manually configured IP address, while

 

the value "0.0.0.0" is not indicated at all, no matter whether assumed by default

 

or explicitly specified.

 

See also note below.

“dns2“

Secondary DNS server address (IP address in dotted-four-byte format).

 

If "dns1" = "0.0.0.0" this setting will be ignored. Otherwise this value can be

 

used to manually configure an alternate server for the DNS1.

 

If "dns1" is not equal "0.0.0.0" and no "dns2" address is given, then

 

"dns2"="0.0.0.0" will be assumed automatically. The AT^SICS read command

 

only returns a manually configured IP address, while the value "0.0.0.0" is not

 

indicated at all, no matter whether assumed by default or explicitly specified.

<conParmValue>(str)

Parameter value; type and supported content depend on related <conParmTag>.

<conParmValue-conType>(str)

Supported connection type values in <conParmValue> for <conParmTag> value "conType".

“CSD“

Circuit-switched data call.

“GPRS0“

GPRS connection.

 

Settings of GPRS related commands are not used, e.g. AT+CGDCONT. When a

 

service based on a GPRS connection profile is started after entering AT^SISO

 

AC75 automatically tries to attach to the GPRS. Yet, the only exception is

 

AT+CGATT which can be used any time to detach from the GPRS and, and thus

 

disconnect the bearer opened with AT^SISO.

“none“

Clears the connection profile.

<conParmValue-alphabet>(str)

Character set selectable with <conParmValue> for <conParmTag> value "alphabet".

[“0“]

Character set determined with AT+CSCS applies.

“1“

International Reference Alphabet (IRA, seven bit ASCII) applies.

<conParmValue-dataRate>(str)

Supported data rate values in <conParmValue> for <conParmTag> value "dataRate".

“0“

14.4 KBaud

[“1“]

9.6 KBaud

AC75_ATC_V01.002

Page 258 of 569

10/30/06

Confidential / Released

 

 

Page 258
Image 258
Siemens AC75 manual Mode, ConParmValuestr, ConParmValue-conTypestr, ConParmValue-alphabetstr, ConParmValue-dataRatestr