Siemens AC75 manual AT+COPS Operator Selection, At+Cops=?

AC75 AT Command Set

8.2 AT+COPS

s

8.2AT+COPS Operator Selection

AT+COPS queries the present status of the AC75's network registration and allows to determine whether auto- matic or manual network selection shall be used. Additional service is available with AT^SOPS.

Three operator selection modes are available:

•Automatic

AC75 searches for the home operator automatically. If successful the AC75 registers to the home network. If the home network is not found, AC75 goes on searching. If a permitted operator is found, AC75 registers to this operator.

If no operator is found the AC75 remains unregistered.

•Manual

Desired operator can be determined using the AT+COPS write command. If the operator is found, AC75 reg- isters to it immediately. If the selected operator is forbidden, the AC75 remains unregistered.

•Manual/automatic

The ME first tries to find the operator determined via AT+COPS write command. If the ME is able to register to this operator, it enters the manual operator selection mode. If the ME cannot find this operator or fails to register to this operator, then it enters the automatic operator selection mode and starts to select the home operators network or another (permitted) one. If the ME is registered and the manually selected network is not available, the ME will remain registered without further result code notification.

The most recently entered operator selection mode is still valid after the ME was restarted (power-off/on).

The AT+COPS test command lists sets of four parameters, each representing an operator present in the network. A set consists of

•an integer indicating the availability of the operator,

•long alphanumeric format of the operator's name and

•numeric format representation of the operator.

Any of the parameters may be unavailable and will then be an empty field (,,). The list of operators comes in the following order: Home network, networks referenced in SIM and other networks.

The operator list is followed by a list of the supported <mode>s and <format>s. These lists are delimited from the operator list by two commas.

If the test command is used during an ongoing GPRS transfer, traffic will be interrupted for up to one minute.

The AT+COPS read command returns the current <mode> and the currently selected operator. If no operator is selected, <format> and <oper> are omitted.

The AT+COPS write command forces an attempt to select and register to the GSM network operator (see note below). If the selected operator is not available, no other operator will be selected (except <mode>=4). The selected operator name <format> will apply to further read commands, too.

Command settings are effective over all serial interfaces of the AC75.

Syntax

Test Command

AT+COPS=?

Response(s)

+COPS: [list of present operators (<opStatus>, long alphanumeric <oper>s,,numeric <oper>s ], , (list of supported <mode>s), (list of supported <format>s)

OK ERROR

+CME ERROR: <err>

AC75_ATC_V01.002	Page 195 of 569	10/30/06
Confidential / Released