Siemens AC75 manual ATD*98#, ATD*99#, ATDmemn

AC75 AT Command Set

23.8 Alphabetical List of AT Commands

s

	AT Command	Description	Section and Page
	AT^SRTC	Ring tone configuration	Section 18.19, page 479
	AT^SSCNT	Start and Stop Pulse Counter	Section 20.9, page 519
	AT^SSCONF	SMS Command Configuration	Section 13.26, page 399
	AT^SSDA	Set SMS Display Availability	Section 13.27, page 400
	AT^SSET	Indicate SIM data ready	Section 14.6, page 412
	AT^SSIO	Set IO state of a specified pin or port	Section 20.7, page 516
	AT^SSMSS	Set Short Message Storage Sequence	Section 13.28, page 401
	AT^SSPI	Serial Protocol Interface	Section 19.8, page 496
	AT^SSTA	SAT Interface Activation	Section 16.1, page 428
	AT^SSTGI	SAT Get Information	Section 16.3, page 431
	AT^SSTR	SAT Response	Section 16.4, page 432
	AT^SSYNC	Configure SYNC Pin	Section 19.7, page 493
	AT^STCD	Display Total Call Duration	Section 7.28, page 192
	AT^STPB	Transmit Parity Bit (for 7E1 and 7O1 only)	Section 4.11, page 123
	AT^SWDAC	Configure and Read PWM Signal for DAC	Section 19.9, page 506
	AT^SXSM	Extended SIM Access	Section 14.4, page 408
	ATA	Answer a call	Section 7.2, page 157
	ATA	Manual response to a network request for PDP context	Section 11.17, page 344
		activation
	ATD	Mobile originated call to specified number	Section 7.3, page 158
	ATD*98#	Request GPRS IP service	Section 11.19, page 346
	ATD*99#	Request GPRS service	Section 11.18, page 345
	ATD><mem><n>	Mobile originated call using specific memory and index	Section 7.4, page 160
		number
	ATD><n>	Mobile originated call from active memory using index	Section 7.5, page 162
		number
	ATD><str>	Mobile originated call from active memory using corre-	Section 7.6, page 163
		sponding field
	ATDI	Mobile originated call to ISDN number	Section 7.7, page 164
	ATDL	Redial last number used	Section 7.8, page 165
	ATE	Enable command echo	Section 4.5, page 109
	ATH	Disconnect existing connection	Section 7.9, page 166
	ATH	Manual rejection of a network request for PDP context	Section 11.20, page 347
		activation
	ATI	Display product identification information	Section 6.1, page 150
	ATL	Set monitor speaker loudness	Section 18.2, page 457
	ATM	Set monitor speaker mode	Section 18.3, page 457
	ATO	Switch from command mode to data mode / PPP online	Section 7.17, page 175
		mode
	ATP	Select pulse dialing	Section 7.29, page 193
	ATQ	Set result code presentation mode	Section 2.4, page 37
	ATS0	Set number of rings before automatically answering a call	Section 7.12, page 170
	ATS0	Automatic response to a network request for PDP context	Section 11.21, page 348
		activation
AC75_ATC_V01.002		Page 568 of 569	10/30/06

Confidential / Released