Siemens AC75 manual Atmonp Monitor neighbour cells, Atmonp=?, ATMONP=period

AC75 AT Command Set

8.10 AT^MONP

s

8.10AT^MONP Monitor neighbour cells

The AT^MONP supplies information of up to six neighbour cells. There are two ways to retrieve the information: once on request by using the execute command or automatically every <period> seconds by using the write command. To stop the periodic presentation type "AT" or "at".

Syntax

Test Command

AT^MONP=?

Response(s)

^MONP:(list of supported <period>s)

OK

Exec Command

AT^MONP

Response(s)

See: Section 8.10.1, AT^MONP responses

OK

Write Command

AT^MONP=<period>

Response(s)

See: Section 8.10.1, AT^MONP responses

OK ERROR +CME ERROR

Reference(s)

SIEMENS

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

- + + + + + + - - -

Parameter Description

<period>(num)

Display period in seconds 1...254

Notes

•Due to the fact that not all necessary information of the neighbour cells can be decoded during a connection, there are several constraints to be considered:

-Only neighbour cells that have already been visible in IDLE mode will be further updated, as long as they are still included in the list.

-Though new neighbour cells can be added to the list (e.g. due to handover), their C1 and C2 parameters cannot be displayed until the connection is released. In this case "-" is presented for C1 and C2.

-To some extent, the cell monitoring command AT^SMONC covers the same parameters. The receiving level, for example, can be queried with both commands. Yet the resulting values may be slightly different, even though obtained over a time period of a few seconds. This is quite normal and nothing to worry about, as the cell information is permanently updated.

•For compatibility with earlier products and to support legacy applications, any input character may be used to stop the output in certain cases (depending on the settings of AT+IPR and AT+CMUX).

•If the ME is Java controlled, periodic retrieval of cell information using the write command AT^MONP=<period> is not supported. If periodic cell information is required simply repeat the execute com- mands at regular intervals.

AC75_ATC_V01.002	Page 213 of 569	10/30/06
Confidential / Released