Siemens AC75 manual Atsrsa Remote SIM Access Activation, Atsrsa=?, Atsrsa?

AC75 AT Command Set

15.1 AT^SRSA

s

15.1AT^SRSA Remote SIM Access Activation

The AT^SRSA write command enables and disables RSA connections and allows to control the AC75's SIM usage scheme.

The AT^SRSA read command requests the current RSA status. Every line indicates an RSA connection, if any.

Syntax

Test Command

AT^SRSA=?

Response(s)

^SRSA:(list of supported <devId>s) , (list of supported <sapRole>s) , (list of supported <muxChan>s) , (list of supported <dataForm>s) , (list of supported <beaconPer>s) , (list of supported <discType>s)

OK

Read Command

AT^SRSA?

Response(s)

[^SRSA:<devId>, <sapRole>, <connState>, <muxChan>, <dataForm>, <beaconPer>]

OK

Write Command

AT^SRSA=<devId>, <sapRole>[, <muxChan>[, <dataForm>[, <beaconPer>[, <discType>]]]]

Response(s)

^SRSA:<actResult>

OK

Reference(s)

SIEMENS

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

- + + + + + + - - -

Unsolicited Result Code

^SRSA: <devId>, <sapRole>, <connState>, <linkChangeCause>

This URC is generated if either the SIM usage scheme or the SAP connection status has changed due to SAP message communication or AT command control.

Parameter Description

<actResult>(num)

	Activation result
0		No Error
		Parameters valid, SAP mode change initiated. However, actual mode change
		is signaled via URC "^SRSA".
		Other values indicate invalid activation requests, no SAP mode change is initi-
		ated in the following cases:
1		Error unspecified.
2		Error activation command is busy.
3		Error activation started with serial multiplex mode is off.
4		Error activation started on invalid serial multiplex channel.
5		Error device Id is already known.
6		Error SAP mode is already active.
7		Error invalid parameter.
AC75_ATC_V01.002		Page 418 of 569	10/30/06
Confidential / Released