Siemens AC75 manual PDelFlag

AC75 AT Command Set

10.3 AT^SISS

s

smAuth	SMTP authentication control flag (numeric).
	If disabled (<srvParmValue> "0" by default), AC75 performs action without
	SMTP authentication.
	If enabled (<srvParmValue> "1") authentication procedure with the SMTP
	server will be performed by means of supported authentication methods, using
	values of "user" and "passwd" parameters. If AC75 and SMTP server are not
	able to negotiate an authentication mechanism supported by both parties, the
	AC75 continues action without authentication.
	AC75 supports SMTP authentication.
pCmd	POP3 user command to be executed by the POP3 service (numeric).
	For supported values of <srvParmValue> refer to <srvParmValue-pCmd>.
pNumber	Optional message number argument used by the POP3 commands List ("2"),
	Retrieve ("3") and Delete ("4"). For POP3 commands see <srvParmTag>
	value "pCmd".
	Length: 0 ... 232-1
	If no specific value is set in the service profile, the value "0" is assumed by
	default, i.e. "pNumber" is disabled.
pLength	Maximum message length (string, optional)
	Length: 0 ... 232-1
	"pLength" can be used to specify the length of the message(s) to be retrieved
	from or deleted on the POP3 server. If no specific value is set in the service
	profile, the default value "0" is assumed, which means that there is no limit on
	the message size.
	A warning will be issued inthe following cases:
	• If "pNumber" > 0 and a specific message to be retrieved from / deleted on
	the server is longer than "pLength".
	• If "pNumber" = 0 and all messages to be retrieved from / deleted on the
	server are longer than "pLength".
	No warning will be issued in the following cases:
	• If there are no messages at all on the server.
	• If the server has message(s) below and above the "pLength" specified. In
	this case, the message(s) within the range of "pLength" can be successfully
	retrieved or deleted, but the message(s) above "pLength" remain on the
	server without any further notification given to the user.
	• Therefore, after retrieving / deleting messages, it is recommended to check
	the message status on the server. This can be done by adding a further
	POP3 service profile using the POP3 user command List ("2").
pDelFlag	Flag to be used with the POP3 user command Retrieve ("3"). Specifies whether
	or not to delete retrieved emails on the server (optional).
	For supported values of <srvParmValue> refer to <srvParmValue-
	pDelFlag>.
tcpMR	Parameter can be used to overwrite the global AT^SCFG parameter "Tcp/
	MaxRetransmissions" <tcpMr> for a specific Internet Service connection pro-
	file. If the parameter is not specified the value specified with AT^SCFG will be
	used.
	Supported values <srvParmValue> for this parameter are the same as
	described for <tcpMr>.
	Setting is not relevant for Internet Service "Socket" whit type "UDP".
tcpOT	Parameter can be used to overwrite the global AT^SCFG parameter "Tcp/Over-
	allTimeout" <tcpOt> for a specific Internet Service connection profile. If the
	parameter is not specified the value specified with AT^SCFG will be used.
	Supported values <srvParmValue> for this parameter are the same as
	described for <tcpOt>.
	Setting is not relevant for Internet Service "Socket" whit type "UDP".

AC75_ATC_V01.002	Page 269 of 569	10/30/06
Confidential / Released