AC75 AT Command Set

20.2 AT^SCPIN

s

20.2AT^SCPIN Pin Configuration

The AT^SCPIN write command serves to add (or remove) and configure pins.

Syntax

Test Command

AT^SCPIN=?

Response(s)

^SCPIN:(list of supported <mode>s), (list of supported <pin_id>s), (list of supported <direction>s), (list of supported <startValue>s)

OK

Write Command

AT^SCPIN=<mode>, <pin_id>, <direction>[, <startValue>]

Response(s)

OK ERROR

+CME ERROR: <err>

Reference(s)

SIEMENS

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

-

+

+

+

+

+

+

-

+

-

Parameter Description

<mode>(num)

0

Close pin

 

 

1

Open pin

 

 

 

 

 

 

 

 

<pin_id>(num)

 

 

 

 

Pin identifier

 

 

 

0

GPIO1

 

 

1

GPIO2

 

 

2

GPIO3

 

 

3

GPIO4

 

 

4

GPIO5

 

 

5

GPIO6

 

 

6

GPIO7

 

 

7

GPIO8

 

 

8

GPIO9

 

 

9

GPIO10 - The GPIO10 pin can be used either as GPIO or as pulse counter. If

 

 

configured as GPIO, the pulse counter option cannot be enabled. Vice versa,

 

 

if configured as pulse counter the GPIO option is not available. See AT^SCCNT

 

 

and AT^SSCNT for further details on the pulse counter.

 

 

 

 

 

 

 

 

<direction>(num)

 

 

 

 

Parameter <direction> is mandatory when opening a pin, but can be omitted when closing a pin

 

 

0

Input

 

 

1

Output

 

 

 

 

 

 

 

AC75_ATC_V01.002

Page 509 of 569

10/30/06

Confidential / Released

 

 

 

Page 509
Image 509
Siemens AC75 Atscpin Pin Configuration, Atscpin=?, ATSCPIN=mode, pinid, direction, startValue, Pinidnum, Directionnum