AC75 AT Command Set

15.1 AT^SRSA

s

<dataForm>(num)

SAP message data format

 

[0]

XSAP ATC/URC format

 

SAP messages are translated into ASCII coded strings and transmitted as

 

parameters of the AT^SRSM command and the "^SRSM" URC. When using a

 

Bluetooth modem with AT command interface for transmitting data, it is recom-

 

mended to choose the XSAP data format. Note that AT commands not related

 

to RSA shall not be used after RSA activation on the dedicated serial multi-

 

plexer channel.

1

SAP transparent binary format

 

SAP messages are transmitted as coded in the SAP specification. This data

 

format should be selected for transmitting SIM data to a Bluetooth stack which

 

is part of the application. The binary data will be exchanged transparently with

 

the ME. However, the SAP data format does not need ASCII character conver-

 

sion. As a result less data will be transferred and the SIM communication will

 

be faster.

 

 

<beaconPer>(num)

 

Beacon period

 

0...[6]...100

Specifies the number of seconds the SAP client waits before sending the next

 

CONNECT_REQ message. A 0 value leads to a one-time connection request.

 

This parameter is applicable for SAP client activation only.

 

 

<discType>(num)

 

SAP disconnection type

 

This parameter is only applicable if <sapRole> equals 0.

Calls or active GPRS contexts via a remote SIM will be lost due to missing SIM access. Use of AT+CLCC is rec- ommended to query call states before RSA deactivation.

0

Hold SAP role

 

SAP connection is going to be disabled. The AC75 remains in SAP mode and

 

is ready to (re)establish an SAP connection. If an SAP connection was ongoing

 

a URC "^SRSA: <devId>, <sapRole>, <connState>, <linkChange-

 

Cause>" with <connState>= 0 is issued.

 

• A server exclusively sends an SAP message DISCONNECT_IND (type

 

"Graceful") to the client.

 

• A client saves the SIM data temporarily held in the AC75's memory to the

 

remote SIM and sends the DISCONNECT_REQ message to the server. If

 

requested the client restarts sending CONNECTION_REQ messages. If a

 

local SIM is attached the AC75 will use it to register to the network until a

 

server offers its SIM again.

[1]

Stop SAP operation

 

SAP connection is disabled and AC75 is forced to local SIM mode. A URC

 

"^SRSA: <devId>, <sapRole>, <connState>, <linkChangeCause>" with

 

<sapRole>= 0 and <connState>= 0 is issued.

• A server sends a DISCONNECT_IND message (type "Immediate") to the client and returns to local SIM mode immediately. SIM data temporarily held in the client's memory would be lost.

• A client exclusively sends the DISCONNECT_REQ message to the server. Without saving temporarily held data to a remote SIM or waiting for DISCONNECT_RESP the client immediately returns to local SIM mode.

AC75_ATC_V01.002

Page 420 of 569

10/30/06

Confidential / Released

 

 

Page 420
Image 420
Siemens AC75 manual DataFormnum, BeaconPernum, DiscTypenum, URC Srsa devId , sapRole , connState , linkChange