Siemens AC75 manual ATZ Set all current parameters to user defined profile, ATZvalue

AC75 AT Command Set

2.8 ATZ

s

2.8 ATZ Set all current parameters to user defined profile

ATZ sets all current parameters to the user profile stored with AT&W. If a connection is in progress, it will be ter- minated.

All defined GPRS contexts which are not activated or not online will be undefined if the non volatile storage of CGDCONT settings is not activated by the AT^SCFG parameter "GPRS/PersistentContexts" (see AT+CGDCONT). The user defined profile is stored to the non-volatile memory.

Syntax

Exec Command

ATZ[<value>]

Response(s)

OK

Reference(s)

V.250

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

- + + + + + + - + -

Parameter Description

<value>(num)

[0] Reset to user profile

Notes

•First the profile will be set to factory default (see AT&F). If there is a valid user profile (stored with AT&W), this profile will be loaded afterwards.

•Any additional commands on the same command line may be ignored. A delay of 300 ms is required before next command is sent, otherwise "OK" response may be corrupted.

AC75_ATC_V01.002	Page 41 of 569	10/30/06
Confidential / Released