Siemens AC75 manual ATSICS=conProfileId, conParmTag, conParmValue, Alphabet, ARate, DataType

AC75 AT Command Set

10.1 AT^SICS

s

Write Command

AT^SICS=<conProfileId>, <conParmTag>, <conParmValue>

Response(s)

OK ERROR

+CME ERROR: <err>

		PIN	ASC0 ASC1		USB	MUX1	MUX2	MUX3 Charge		4	Last
		-	+	+	+	+	+	+	-	+	-
Parameter Description
<conProfileId>(num)
0...5	Internet connection profile identifier.
	The <conProfileId> identifies all parameters of a connection profile, and,
	when a service profile is created with AT^SISS the <conProfileId> needs
	to be set as "conId" value of the AT^SISS parameter <srvParmTag>.
<conParmTag>(str)
Internet connection parameter.
“conType“	Type of Internet connection.
	For supported values of <conParmValue> refer to <conParmValue-con-
	Type>.
“alphabet“	Selects the character set for input and output of string parameters within a pro-
	file.
	The selected value is bound to the specific profile. This means that different
	profiles may use different alphabets. Unlike other parameters the alphabet can
	be changed no matter whether the <conParmTag> value "conType" has been
	set.
	For supported values of <conParmValue> refer to <conParmValue-
	alphabet>.
“user“	User name string: maximum 32 characters (where "" is default).
“passwd“	Password string: maximum 32 characters (where ***** is default).
	If <conParmValue-authMode>is "MsChapV1" then the maximum password
	length is 16 characters.
“apn“	Access point name string value: maximum 100 characters (where "" is default).
“inactTO“	Inactivity timeout value in seconds: 0 ... 216-1, default = 20
	Number of seconds the bearer remains open although the service no longer
	needs the bearer connection.
	Do not set the timeout value below 3 sec. This may result in problems when
	using the <eodFlag> (set in the last AT^SISW command to terminate an
	upload data stream).
	The value -1 indicates that, after opening the bearer with AT^SICO, the inac-
	tivity timeout is currently disabled. Closing the bearer with AT^SICC restores
	the previously set "inactTO" value of the concerned connection profile.
“calledNum“	Called BCD number.
“dataRate“	Data rate.
	For supported values of <conParmValue> refer to <conParmValue-dat-
	aRate>.
“dataType“	Data call type.
	For supported values of <conParmValue> refer to <conParmValue-
	dataType>.

AC75_ATC_V01.002	Page 257 of 569	10/30/06
Confidential / Released