Siemens AC75 manual Succstr+CSCS

AC75 AT Command Set

2.14 AT^SCFG

s

<succ>(str)(+CSCS)

CIEV Call Status Indication

This parameter can be used to control the behaviour of URC "+CIEV: call". See also AT+CIND, AT+CMER and Section 7.1, Call Status Information.

Parameter is global for all interfaces and will not be reset by AT&F.

“restricted“(P)	URC "+CIEV: call" will be issued only when a Call Status transition ends in
	state "active" or "unknown" (see Section 7.1, Call Status Information) for a call
	in the list of active calls.
“verbose“	URC "+CIEV: call" will be issued when any state transition (including transi-
	tions beginning or ending in state "unknown") occurs in the list of active calls,
	or when a traffic channel is established.
<sucs>(str)(+CSCS)
SLCC Call Status Indication

This parameter can be used to control the behaviour of URC "^SLCC". See also AT^SLCC and Section 7.1, Call Status Information.

Parameter is global for all interfaces and will not be reset by AT&F.

“restricted“	URC "^SLCC" will be issued only when a Call Status transition ends in state
	"active" or "unknown" (see Section 7.1, Call Status Information) for a call in the
	list of active calls
“verbose“(P)	URC "^SLCC" will be issued when any state transition (including transitions
	beginning or ending in state "unknown") occurs in the list of active calls, or
	when a traffic channel is established.
<uri>(str)(+CSCS)
URC RING line

This parameter can be used to control the behaviour of the RING line to indicate URCs (both for idle interfaces and, if configured by the parameter "URC/Datamode/Ringline", if link is reserved) and, if configured, the indicator for incoming IP packets (see parameter "GPRS/RingOnIncomingData" (<groid>).

Parameter is local for the interface, volatile and will not be reset by AT&F.

“off“	URC is not indicated by RING.
“local“(P)	URC will be indicated by an activated RING line of the interface on which the
	URC appears
“asc0“	URC is indicated by an activated RING0 line.
<udri>(str)(+CSCS)
URC Datamode RING line

This parameter specifies whether RING or BREAK is used for the signaling of URCs when the TA-TE link is reserved (e.g. during circuit-switched data calls, fax connections, in GPRS data mode or during the execution of an AT command).

Parameter is global for all interfaces, volatile and will not be reset by AT&F.

“off“(P)	URC will be indicated by BREAK
“on“	URC is indicated by an active RING line for a time which is configured by the
	parameter "URC/Ringline/ActiveTime" (<urat>). The RING line which will be
	used, can be configured by the parameter "URC/Ringline" (<uri>).

AC75_ATC_V01.002	Page 73 of 569	10/30/06
Confidential / Released