Surf Control 5.2.4 manual END-USER Control, End-user Bypass Anti-Spam Setting, User List

2

SYSTEM SETTINGS

User Management

END-USER CONTROL

Authorized users can log in to PEM with their own account and password, validated by a ‘User Validation’ connection and, depending on the settings in the Users List pane, can manage their own Black and White lists. To use PEM, a User Validation connection with ‘Account Authentication’ must be set up for End-Users to manage their own Black/White Lists.

Use the End User Control screen to set up End User Control.

Figure 2 - 32 The End-User Control screen

End-user Bypass Anti-Spam Setting

You can allow listed users to receive mail without an Anti-Spam check being run on them. If you have a user who must receive all messages, regardless of type, then this will prevent important messages being isolated as spam. It also can help where the type of mail a user receives results in a lot of false positives.

User List

You can specify users or lists of users then apply one of two conditions to them:

•Enable White List & Black List for all EXCEPT the address list below – Everyone EXCEPT the users listed can manage their Black/White Lists.

•Enable White & Black List ONLY for the address list below – ONLY the users listed can manage their Black/White Lists.

Setting up End User Control

To set up End User Control:

1Select User Management > End-User Control from the System Settings tab.

2Select Enable end-users to bypass Anti-Spam checking.

3Decide who you want to apply the settings to and select the option that matches the way you want to apply the setting (see above).

4In the Enter user e-mail address: field enter a domain or e-mail addresses in one of the following ways:

•Enter the e-mail addresses of all users that you want to apply the settings to, e.g. user@mydomain.com

•Enter *@ followed by the domain – all users in that domain will be included in the list.

52 Administrator’s Guide SurfControl RiskFilter - E-mail V5.2.4