Agilent Technologies Agilent E5250A manual To change the channel configuration mode

Controlling the E5250A

Using Virtual Front Panel Utility

Figure 5-9	Example of SETUP MODE MENU
	Agilent E5250A Virtual Front Panel Utility
	** SETUP MODE MENU **

CONFIG MODE : NORMAL
CARD1 [E5252]	BIAS STATE	BIAS PORT
	OFF	10
CARD2 [E5252]	OFF	10
CARD3 [E5255]	OFF	--
CARD4 [E5255]	OFF	--

!! CAUTION !!

If any setting parameter of this menu is changed, all setup memory will be cleared.

Select desired softkey.

To change the channel configuration mode

Select the CHANGE CONFIG softkey. This softkey toggles the configuration mode between AUTO and NORMAL.

To change the Bias Port (for the E5252A only)

Select the BIAS PORT softkey. The following message is displayed:

Input Bias Port Number.

Type input port number (1 to 10 is available) to use as bias port, then press Enter key. To cancel operation, press Enter key without typing a number.

To change the Bias Mode state

Select BIAS STATE softkey. This softkey toggles the state OFF/ON.

To enter/cancel the changes and return to the VFP main menu

Select MAIN MENU softkey. If you did not make changes, Main Menu is displayed. If you made changes, following message/softkeys are displayed:

Changing mode will clear all setup memory. OK?

Softkey	Description
CHANGE	Enters the changes you made, and returns to the VFP main menu.
MODE	All the previous setup memory data is cleared.
CANCEL	Cancels the changes you made, and returns to the VFP main
	menu. Setup memory data is not cleared.
5-30	Agilent E5250A User’s Guide, Edition 9