Honeywell VRX180 Load/Store Configuration, Load/Store Config Files Prompts, Disk DRYER01 PROD01

Programming Function Blocks and Features

4.23 Load/Store Configuration

Instrument configurations can be stored to and loaded from floppy disk. The front door must be closed. Configurations have filename extension .LNC.

Table 4-69 describes the Load/Store Config prompts.

Table 4-69 Load/Store Config Files Prompts

Prompt	Range/Selections		Definition
STORE CONFIG TO	FILE01	CYCLE01	Specify a filename and number (01-99) for the
DISK	DRYER01	PROD01	configuration. Press Enter to store the configuration.
	RECORD01	TANK01
	UNIT01	LOOP01
	REACTR01	CONFIG01
	KILN01	VESSEL01
	CALIB01	WCHEM01
	PRESS01	FURNCE01
	DEMIN01	CONTRL01
	BATCH01	FERMTR01
	LEHR01	LINE01
	STRLZR01	OVEN01
	ZONE01
LOAD CONFIG	Select a configuration		First you must clear the instrument’s configuration memory.
FROM DISK	filename.		Press Enter to clear, or Menu to abort and exit the menu.
			Once the memory is clear, select a filename from the floppy
			disk. Press Enter to load the configuration into the
			instrument.

ATTENTION

Only function blocks that have been programmed are loaded to the instrument. Function blocks in the receiving instrument are not replaced unless the incoming function blocks are programmed differently. For example, if the instrument has AI1 and AI2 programmed, and the configuration being loaded from the floppy contains AI3 only, then AI1 and AI2 are undisturbed on the instrument and AI3 is added. If the configuration being loaded contains a different AI2 and a new AI3, then AI1 is undisturbed, AI2 is replaced by the different AI2, and AI3 is added.

Video Recorder – User Manual 163