Honeywell VRX180 user manual Messages and Symbols Elsewhere on Display, General Error

				Online Operations Using Primary Displays
	Table 6-6 Messages and Symbols at Bottom of Display (continued)
	Message/Symbol	Color		Description
	GENERAL ERROR	Yellow	This message will appear if the instrument encounters any error not
			mentioned above.
	S	Yellow	Located in bottom right of display. Indicates storage is active data is
			being collected on disk or in the instrument’s internal buffer.
	Z	White	Located in bottom right of display. The display’s upper and lower
			limits are zoomed on a smaller range. Disappears when Zoom is
			turned off.
	H	White	Located in bottom right of display. Indicates the display is held on a
			single data point and is not rotating through all data points.
			Disappears when Point Hold is removed.
	Table 6-7 Messages and Symbols Elsewhere on Display
	Message/Symbol	Color		Description
	REVIEW or REPLAY	White		Trend Replay/Review. Adjacent to detailed point information
				(scoreboard) on the screen. Indicates that the trend on the display
				is from historical data and does not represent the current state of
				the process. REVIEW means that the data for the trend are from
				current memory (RAM). REPLAY means that the data are retrieved
				from floppy disk (data storage).
*		White		Analog Input Value Adjust. Located to the right of the data point
				value. This message appears only on the AI Value Adjust display.
				It indicates that a bias has been manually applied to the value of the
				particular data point. The symbol will disappear when the value is
				set to OFF.
		Red		Low Alarm Setpoint. Located above vertical trends, right of
				horizontal trends, along side of bar graph. These symbols appear
				automatically if a displayed point is the input to one or more Alarm
				function blocks. The first 4 low type alarm blocks using the
				displayed points are represented by these symbols.
	or	Red		High Alarm Setpoint. Located above vertical trends, right of
				horizontal trends, or along side of bar graph. These symbols
				appear automatically if a displayed point is the input to one or more
				Alarm function blocks. The first 4 high type alarm blocks using the
				displayed points are represented by these symbols.
	Flashing between ******	Same as		Bad Input Values. Appears in place of the value on all displays.
	and value	data point		Value is outside the programmed limits. Caused by an upstream AI
				failure (AI is open circuit and failsafe or is type linear and outside its
				programmed range by 10% or more).
	Flashing between value	Same as		Questionable Input Values. Appears in place of the value on all
	and blank	data point		displays. Value is clamped at its limit.
	Flashing between value	Same as		Output Limits of Totalizer or Interval Timer Exceeded. Appears in
	and blank	data point		place of the value on all displays. Interval Timer ‘s or Totalizer’s
				value is outside its output limits. Value is not clamped.

Video Recorder – User Manual 219