Honeywell VRX180 user manual Softwares and Support Parts

Introduction

Model Selection Guide (cont.)

						VRX180
TABLE V - OPTIONS (continued)						Selection
Approvals		CE Mark Compliant				_ _ _ 0 _ _
		CSA/NRTLc/CE Mark				_ _ _ C _ _
Software		None				_ _ _ _ 0 _
		SDA and SCF				_ _ _ _ B _
		SCF (Configuration Software)				_ _ _ _ C _
		SDA (Data Analysis Software)				_ _ _ _ E _
Case		Galvanized Case, Grey Door, Glass Window, Latch				_ _ _ _ _ 0
		Galvanized Case, Grey Door, Glass Window, Key Lock				_ _ _ _ _ 1
		Galvanized Case, Grey Door, Plastic Window, Latch				_ _ _ _ _ 2
		Galvanized Case, Grey Door, Plastic Window, Key Lock				_ _ _ _ _ 3
		Portable Case (Painted Case, Handles)				_ _ _ _ _ 6
TABLE VI
Factory Use Only						00
SOFTWARES AND SUPPORT PARTS						Part #
SDA Data Analysis Software (can be ordered separately if not selected in Table V)						045501
SCF Configuration Software (can be ordered separately if not selected in Table V)						045502
SDI Disk Initialization Software			(Note 6)			46193351-501
Kit of 4 resistors 250 Ohms for 4-20 mA input						46181080-503
RESTRICTIONS
Restriction Letter			Available With		Not Available With
	Table		Selection	Table	Selection
c				II	_ _ _ _ _ A, _ _ _ _ _ B, _ _ _ _ _ C,
					_ _ _ _ _ E, _ _ _ _ _ R, _ _ _ _ _ G,
					_ _ _ _ _ H, _ _ _ _ _ M

Notes:

1.The available algorithms include: PID (standard and advance), Cascade, Split Output and On/Off. The appropriate outputs from Table I must be specified - Current or Relays.

If Split (Duplex) output Control is required, advance math must be selected ( Table III ).

2.Standard Math includes 24 Calculated Values and the following pre-packaged algorithms

Free Form Math	Logic Operators	Flip-Flop/One Shot		Periodic Timer
Free Form Logic	Math Operators	Invertor
Advance Math includes 64 Calculated Values and the following additional of pre-package algorithms.
Signal Select	Interval Timer	Counter
Compare	Relative Humidity	Scaling
Signal Clamp	Mass Flow	Advanced Splitter
Peak Picking	Fo Calculation	Continuous Emissions Monitoring
Function Generator	Multiple Input Average	-	CEM Block Average
Carbon Potential	Single Point Average	-	CEM Rolling Average
Rolling Average	Standard Splitter

3.Customer must supply Input Actuation Type and Range for each input for inclusion in the free form section of the Factory order to supply the Custom Calibration Certificate, otherwise the calibration will be based on the factory default ranges.

4.When selecting SP program make sure to select analog output (current) as necessary (Table II slot N,P).

5.When selecting Control loops, make sure to select outputs (as necessary in Table II)

6.Provided with each VRX180 are : one pre-initialized disk and one SDI software pack. SDI software should be installed on a PC and used for initialization of new disks.

7.Must purchase Table II _ _ _ _ M _ in order to select Table II Selection _ _ _ _ _ M.

12 Video recorder – User Manual