Honeywell VRX180 user manual To perform this action Do these steps

Online Operations Using Primary Displays

	Table 6-5 Interacting With Loop Displays
To perform this action	Do these steps
Move the cursor box to	Press the Tab key to move the cursor to the Loop Tag at the top of the display,
another area of the display	then to the setpoint value, then to the loop output value (if loop is in Manual
	mode).
Toggle the loop between	Press Auto/Manual button.
Auto and Manual modes	To use the Auto/Manual button all of the following conditions must be met.
	1. Loop must be in Local mode, which means FORCE REMOTE MAN discrete
	parameter must be OFF.
	2. DISCR VS KEY SEL discrete parameter must be OFF.
	3. If security is active for AUTO/MAN changes, the security code must be
	entered first.
	For a description of the loop parameters FORCE REMOTE MAN and DISCR
	VS KEY SEL, see Table 4-10.
Lower or raise the loop	Press Tab key to move cursor to loop output. To change the output, the loop
output (displayed as %).	must be in manual mode (initiated by front panel key or by external discrete
	signal )– not in Remote Manual mode.
Increase or decrease	Press Tab key until cursor is on the setpoint value. Press Increment and
Setpoint value	Decrement to adjust value. Only numerically assigned setpoint values can be
	changed online; Setpoint #2 cannot be changed if it is acting as a remote
	setpoint (e.g. running a profile).
	You can also change the setpoint value by accessing the Tune Loop menu as
	described in the next row.
Access the loop tuning	Press Tab key until the cursor is on the loop tag at the top of the display.
parameters	Press Enter to access the Tune Loop menu for that loop. Adjust desired
	parameters. To return to the loop display, press Menu. See Section 7.6 Tune
	Loop.

216 Video Recorder – User Manual