Honeywell VRX180 user manual Labels for Function Blocks

				Programming Function Blocks and Features
		Table 4-3 Labels for Function Blocks
Prompt		Range/Selections				Definition
DESCR	Enter 16 characters maximum.				Called a descriptor. Usually appears as
						a header or title on some displays and
						reports. For alarms, this is the actual
						alarm message. If labeling is enabled,
						the descriptor can be edited in the
						function block’s program menu.
TAG	Enter 7 characters maximum.				Identifies the point or function on most
						displays and reports. Each tag must be
						unique. If labeling is enabled, the tag
						can be edited in the function block’s
						program menu.
UNITS	Default choices:					Shows units of measure for analog
	PSI	DEGR	GAL	MA		values on most displays and reports.
	BAR	K	LPH	%		This list of units can be changed under
	MW	MV	LPM	PH		the ENGINEERING UNITS menu item. If
						labeling is enabled, the units can be
	GPH	V	LPS	KG
						edited in the function block’s program
	GPM	OHM	LITR	GRAM
						menu.
	GPS	HZ	DEGC	LB
			DEGF
ON STATE	OFF	ON	FILL	DRAIN		Select a label describing the ON(1) state
	UP	DOWN	EMPTY	FULL		of the discrete function. These labels
	START	STOP	IN	OUT		cannot be changed.
	LOW	HIGH	OPEN	CLOSED
	RESET	RUN	HOLD	ACTIVE
	TRUE	FALSE	READY	ABORT
	LEFT	RIGHT	ALARM	NORMAL
	DECRS	INCRS	AUTO	MANUAL
	LOAD	UNLOAD	SP1	SP2
	COOL	HEAT	NO	YES
			PAUSE
OFF STATE	See ON STATE for default choices.					Select a label to describe the OFF (0)
						state of the discrete function. These
						labels cannot be changed.

Video Recorder – User Manual 85