Honeywell VRX180 Frequently used programming prompts, Frequently Used Programming Prompts

Programming Function Blocks and Features

4.4 Frequently used programming prompts

When programming the instrument you will see certain prompts repeatedly in different menus. These are described in Table 4-2, rather than in each menu in which they appear.

Table 4-2 Frequently Used Programming Prompts

Prompt		Range/Selections				Definition
IN DECIMAL POS	X.XXXXX		XXXX.XX			Select the decimal point position to be
	XX.XXXX		XXXXX.X			used for all inputs to the function.
	XXX.XXX		XXXXXX.			Select X.XXEXX to display the function’s
			X.XXEXX			values in exponential notation.
						Example: 1.23E4 means 1.23 x 104 .
OUT DECIMAL POS	Same as IN DECIMAL POS selections				Select the decimal point position that will
						be used for all outputs of the function.
ON LABEL*	OFF	ON	FILL	DRAIN		Select the discrete function’s ON(1)
	UP	DOWN	EMPTY	FULL		state label.
	START	STOP	IN	OUT
	LOW	HIGH	OPEN	CLOSED
	RESET	RUN	HOLD	ACTIVE
	TRUE	FALSE	READY	ABORT
	LEFT	RIGHT	ALARM	NORMAL
	DECRS	INCRS	AUTO	MANUAL
	LOAD	UNLOAD	SP1	SP2
	COOL	HEAT	NO	YES
			PAUSE
OFF LABEL*	Same as ON LABEL selections					Select the discrete function’s OFF state
						label.
DESCR*	Enter up to 16 characters.					Usually appears as a header or title on
						some displays and reports. For alarms,
						this is the actual alarm message.
TAG*	Enter 7 characters maximum.				Identifies the point or function on most
						displays and reports. Each tag must be
						unique.
UNITS*	Default choices:					Shows units of measure for analog
	PSI	DEGR	GAL	MA		values on most displays and reports.
	BAR	K	LPH	%		These 25 choices can be changed. See
						Table 4-4.
	MW	MV	LPM	PH
	GPH	V	LPS	KG
	GPM	OHM	LITR	GRAM
	GPS	HZ	DEGC	LB
			DEGF

* Prompt does not appear if labeling is disabled under ENABLE FEATURES.

82 Video Recorder – User Manual