Creating Graphics

Changing the Scale

Default Scale for P1 and P2

The scale for P1 and P2 may be changed from its preset value to any values between 032,768 and +32,767. Below, SCALE changes the X and Y coordinates to new terms in decibel and degree units to illustrate an antenna pattern adjustment.

Set Scale in Terms of Degrees and Decibels

The SCALE command de￿nes X-Y coordinates in integer values only. When

rede￿ning the scale, use numbers large enough to give adequate resolution. Units greater than 50 are recommended. The NbuildNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNwindowNNNN softkeys also

change the scale of P1 and P2.

The following table list the commands that are a￿ected by the SCALE command.

5-22