Language Reference
ALIGN
| 71451A's MONOCHROMATOR INPUT) before issuing the | |||
| ALIGN command. | |||
AUTOPT | Species that an external | |||
| You must set the stop and start wavelengths prior to | |||
| the alignment. These wavelengths are included in the | |||
| alignment. The alignment takes about 2 or 3 minutes to | |||
| complete. To run this alignment, you must observe the | |||
| following points: | |||
| Connect your own broadband light source to the | |||
|
| |||
| Set the start and stop wavelengths within the input range | |||
|
| of 600 nm to 1700 nm. | ||
| Ensure that the span of the alignment is greater than 10 | |||
|
| nm. | ||
| The signal amplitude must be greater than 078 dBm in a | |||
|
| 10 nm resolution bandwidth at all X's to be aligned. | ||
| If the above conditions are not met, a \Bad Wavelength | |||
| Range" error message is displayed. The alignment occurs | |||
| at equally spaced points between the start and stop | |||
| wavelengths. No points are separated by more than 50 nm. | |||
MANUAL | Runs an 4 |
| 5 at a wavelength apecied by the | |
AUTO ALIGN | ||||
| marker and transfers the results to the ber positioner's | |||
| tracking table. (A maximum of 32 alignments can be |
performed.) Before initiating the alignment, connect your
own light source to the
being added to the tracking table is tested to see if it results in a tracking curve which is too steep. If the curve is too
steep, an error is reported, and the data is not added to the table (neither is the NNNNNNNNNNNNNNNNNNNNNNNNNNNAUTO ALIGNNNN data zeroed). If
the current NAUTONNNNNNNNNNNNNNNALIGNNNNNNNNNNNNNN motor position is close enough
to a motor position already listed in the correction table, the NAUTONNNNNNNNNNNNNNALIGNNNNNN data will replace that entry instead
of generating a new one. This \replacement" limit is wavelength and order dependent, but amounts to about 10 nm at 1300 nm in rst order.