3.9 Operating the Storage Device

4

5

6

7

Press the Z key to display >RAM Disk Size.

>RAM Disk Size

0055 Mbyte

Press the ENTER key again and change the RAM disk size using the U or V key. The value for the RAM disk is between 0001 and 1024 depending on the available printer memory.

When the desired RAM disk size is displayed, press the ENTER key.

Press the MENU key to exit the menu selection. Restart the printer. The setting will be effective after restarting.

3.9.2Reading/Writing to an Option Storage Device

The printer can be equipped with a memory card and a hard disk. For more information about handling a memory card, see Appendix A Options, section A.3.1 Memory Card on page A-7.

The operator panel provides the following operations for the memory card and the hard disk.

Reading fonts, macros, data, programs

Writing data

Deleting data, fonts, programs, macros

Formatting a memory card or hard disk (See Note below)

Printing a list of partitions

The following procedure assumes use of a memory card. The similar procedure can be applied when using a hard disk.

 

You can format the hard disk using the operator panel when the first time you installed a

 

new hard disk. About formatting a new hard disk, see also the Installation Guide of the

Note

hard disk for details.

Reading Fonts

Fonts in a memory card are automatically read into the printer when the memory card is installed in the printer slot when the printer is turned on.

To re-read fonts from a memory card, or to read fonts from the hard disk, use the following procedure:

1

2

Press the MENU key.

Press the U or V key repeatedly until Memory Card > or Hard Disk > appears.

Memory Card

>

 

 

3-70

Page 105
Image 105
HP FS-8000C manual Reading/Writing to an Option Storage Device, RAM Disk Size Mbyte, Memory Card, Reading Fonts