3.5 Changing the Interface Parameters
6 | Press the Z key. One of the following serial parameters is indicated (Baud rate for |
| example). |
Pressing the U or V key toggles through the serial parameters as follows. To change the serial parameter, press the ENTER key. Use the U or V key to change the value or selection.
>Baud rate 9600
>Data bits 8
>Stop bits 1
>Parity None
>Protocol
DTR(pos.)&XON
>Barcode Mode Off
Range
1200, 2400, 4800, 9600 (Default), 19200, 38400, 57600, 115200
7 or 8 (Default)
1 (Default) or 2
None (Default), Odd, Even, or Ignore
DTR (pos.) & Xon (Default), DTR (positive), DTR (neg- ative), Xon/Xoff, ETX/ACK
Off (Default) or On †
†Barcode mode is used when the option barcode reader is connected to the printer to support reading document IDs (barcodes). Note that Barcode Mode appears in the menu only when a hard disk option is installed.
For example, to change baud rate from 9600 to 115200, display the baud rate menu following the above procedure. When the display shows baud rate, 9600 (bps), press the ENTER key. A blinking question mark (?) appears.
>Baud Rate
?9600
