3.5 Changing the Interface Parameters

Press the U or V key to scroll through values. When 115200 is displayed, press the ENTER key. Press the MODE key to exit the menu selection.

Some computers may not be able to handle a baud rate of 115200 bps. If you set the baud rate to 115200 and encounter communication problems, select a lower baud rate.

Note

3.5.3Changing Network Interface Parameters

This section applies to the FS-8000C series printers having the network interface card installed. The FS-8000CN comes equipped with a network interface card as a standard accessory. For details concerning network issues when using the FS-8000CN, refer to the supplied manual for the network interface card.

Using the operator panel, you can:

Activate or deactivate TCP/IP, NetWare, and AppleTalk

Activate or deactivate DHCP

Enter IP address, subnet mask address, and default gateway address

Determine whether to print a network status page when the printer is turned on

To confirm or change network card parameters, proceed as follows:

1

2

Press the MENU key.

Press the U or V key repeatedly until Interface > appears.

3

If the current interface is other than option, press the ENTER key. A blinking question

 

mark (?) appears.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Interface

>

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

? Parallel

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4

Press the U or V key repeatedly until Option appears.

 

 

 

 

 

 

 

 

 

 

 

Interface

>

 

 

 

 

 

 

 

? Option 1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

5

Press the ENTER key again.

6

Press the Z key. One of the following menus is indicated. To change settings for the

 

item, press the ENTER key. Use the U or V key to change the value or selection.

3-41

Page 76
Image 76
HP FS-8000C manual Changing Network Interface Parameters, Interface ? Option