Intel NetStructure® MPCBL0010 Single Board Computer
October 2006 Technical Product Specification
Order Number: 304120 27
Operating the Unit—MPCBL0010 SBC
Note: Jumpers JP2, JP1, JP4, JP9, and JP12 are reserved for future use.
3.2 AdvancedMC Filler Panels
AdvancedMC* filler panels are used to optimize cooling and reduce radiated emissions
when AdvancedMC modules are not installed in theMPCBL0010 SBC AdvancedMC
module slots. Do not operate the MPCBL0010 SBC without filler panels or AdvancedMC
modules installed. AdvancedMC module slots should not be left open or uncovered
when the MPCBL0010 SBC is in use.
The MPCBL0010 SBC uses full-height, half-width AdvancedMC filler panels such as
Schroff* part number # 20849-024 (http://www.schroff.us/).
JP7 IPMC Override
(posts 3-4)
IPMC is completely disabled and
always in RESET mode.
This setting can be used to allow the
MPCBL0010 SBC to boot if the IPMC
firmware is corrupted or non-
functional.
Normal IPMC operation (default)
JP8 FPGA Config User PROM (default) Factory PROM (for manufacturing
purposes only)
JP10 Test Mode Test Mode (for manufacturing
purposes only). Normal (default)
JP11 AdvancedMC PCI-
Express Reference Clock
Override
Override AdvancedMC E-Keying and
provide PCI-Express Reference Clock
to the AdvancedMC connectors.
Use normal AdvancedMC E-keying
(default)
Table 2. Jumper Definitions (Continued)
Name Function with Jumper
Present (On) Function with Jumper
Removed (Off)
Figure 5. AdvancedMC Filler Panel