Intel Intel NetStructure Single Board Computer, MPCBL0010 manual Ipmi Configuration Sub-Menu

MPCBL0010 SBC—BIOS Setup

Main

Advanced	PCIPnP Boot	Security	Chipset	Exit
System Management
Event Log Configuration
MPS Configuration
ATCA Channel Routing (PICMG)
On-board Devices Configuration
PCI Express Configuration

Remote Access Configuration

IPMI Configuration

USB Configuration

Table 44 shows remote access configuration options.

Table 44.	Remote Access Configuration Sub-Menu
	Feature	Options	Description
	Remote Access	Disabled	Enable / Disable Remote Access function.
		Enabled
	Serial Port Number	COM1	Selects serial port for remote access.
		COM2
	Serial Port Base Address		Displays selected serial port base address.
		115200 8,N,1
	Serial Port Mode	57600 8,N,1	Configures the serial port bits per second, data bits, parity,
		38400 8,N,1
			stop bits, and flow control.
		19200 8,N,1
		9600 8,N,1
		None
	Flow Control	Hardware	Enables and configures flow control type.
		Software
	Redirection after BIOS	Always
		Disabled	Specifies when redirection should occur.
	POST
		Boot Loader
		ANSI	Specifies the target terminal type.
	Terminal Type	VT-100
		VT-UTF8
	VT-UTF8 Combo Key	Disabled	Enabled VT-UTF8 combination key support for ANSI and VT-
	Support	Enabled	100 terminals.

Notes:

1.Bold text indicates the default setting.

2.To use the Serial over LAN (SOL) feature described in Chapter 11.0, “Serial Over LAN (SOL)”, the following settings must be used:

-Remote Access = Enabled

-Serial Port Number = COM2

-Flow Control = Hardware

-Redirection after BIOS POST = Always

7.3.12IPMI Configuration Sub-Menu

To access this sub-menu, select Advanced on the menu bar, then IPMI

Configuration.

Intel NetStructure® MPCBL0010 Single Board Computer
Technical Product Specification	October 2006
78	Order Number: 304120