
Operating the
Section 3.4.1). To rotate the cam, the handle must be pushed in towards the SBC when moving the handle up or down.
1. Rotate the lower handle to the horizontal position, and push in to disengage the Hot | ||||
Swap switch (position 1a to 1b). Wait for the Hot Swap LED on the faceplate to turn | ||||
solid blue. |
|
| ||
|
|
| ||
| ||||
|
|
| ||
|
| |||
|
|
|
2.With the handles pushed in, simultaneously pivot the top handle up and the bottom handle down. Using the handles, rotate the latching cam to their farthest point of travel. This is the pitch line— the farthest the handles can be moved without hitting the cable tray or other chassis component.
Note: The handles must be pushed in for the latching cam rotation to occur.
3.Release the handles to allow the ratchet mechanisms to disengage from the cams, and reposition the handles to the horizontal position (the cams will remain at an angle to the horizontal).
| Intel NetStructure® MPCBL0010 Single Board Computer |
October 2006 | Technical Product Specification |
Order Number: 304120 | 31 |