MPCBL0010 SBC—Operating the Unit
3.4.1Chassis Installation
1.Insert the MPCBL0010 SBC into the chassis with the latching cams at a 75º angle. This will set the latching cams into the installation position. Move the latching cam by pressing the handle inward to free the latching cam for rotation.
2.While holding inward pressure on the handle, slide the MPCBL0010 SBC into the chassis. Begin rotating the latching cam back to 0º allowing the cam to assist with insertion. As the SBC is inserted, the AdvancedTCA backplane connectors are mated to the SBC. If necessary, use your thumbs to apply pressure to the SBC faceplate near the handles to make sure the SBC is fully inserted.
Caution: Do not apply pressure to the AdvancedMC faceplate, as this could damage the connectors at the rear of the AdvancedMC module.
3. Once the SBC is installed, rotate the handles into thevertical position.
3.4.2Chassis Extraction
The AdvancedTCA Hot Swap switch is activated by pushing in the lower handle (or the left handle when the SBC is mounted in the horizontal position). When the handle is pushed inward, a small metal slider will activate the Hot Swap switch.
Note: The ratcheting function of the handle allows the handle to be moved without affecting the position of the latching cam that holds the SBC in the chassis (see illustration in
Intel NetStructure® MPCBL0010 Single Board Computer |
|
Technical Product Specification | October 2006 |
30 | Order Number: 304120 |
