MPCBL0010 SBC—Operating the Unit

3.3Installing Memory

DDR2-400 DIMMs must be installed in matched pairs. Memory DIMMs of 1 GBytes or 2 GBytes are supported for a total of 2 Gbytes (2x1 Gbyte) or 4 Gbytes (2x2 Gbytes) of system memory. Matched pairs in this case means a pair of DIMMs equal in speed, density, and technology. Preferably, the same vendor and part number for both pairs. See the MPCBL0010 SBC Compatibility Report on the Intel web site for a list of approved memory part numbers and vendors.

To install memory:

Caution: Electrostatic discharge (ESD) can damage components. Install the memory in an ESD- controlled area. If such an area is not available, wear an antistatic wrist strap or touch the surface of the antistatic package before handling the SBC and memory.

1.Remove all six screws pictured in Figure 6 from the memory access panel on the MPCBL0010 SBC top cover.

Figure 6. Memory Top Cover Installed

￿￿￿￿￿￿￿￿

2. Remove the cover.

Figure 7. Empty DIMM Sockets

￿￿￿￿￿￿￿￿

Intel NetStructure® MPCBL0010 Single Board Computer

 

Technical Product Specification

October 2006

28

Order Number: 304120

Page 29
Image 29
Intel Intel NetStructure Single Board Computer, MPCBL0010 manual Installing Memory, Remove the cover