Intel SR9000MK4U manual Removing a Memory Box, Removing the Memory Box

Removing a Memory Box

To perform this procedure, you will first need to remove the front bezel. The steps below will direct you to the instructions on removing the front bezel at the appropriate location in the step sequence.

Caution: Before performing the procedures in this chapter, except for when hot-swapping, turn off the system and disconnect all power plugs.

1.Remove the front bezel. For instructions, see “Removing the Front Bezel” on page 34.

2.Push down on the memory box release lever to unlock the memory box. See letter “A” in the figure below.

3.Fully open the metal cover on the memory box. See letter “B” in the figure.

4.Carefully pull the memory box from the system and place it on a clean, static-free surface.

B

A

AF001120

Figure 34. Removing the Memory Box

5.Determine your next course of action and refer to the appropriate steps:

—If you are following these steps as part of another procedure, return to that procedure.

—If a memory box will not be re-installed, slide a memory box filler panel into the open memory box slot until it clicks into place.

6.Install the front bezel. For instructions, see “Installing the Front Bezel” on page 35.

Intel® Server System SR9000MK4U Product Guide 45