Removing DIMMs
To perform this procedure, you will first need to remove:
•The front bezel
•The memory box
The steps below will direct you to the instructions for these procedures at the appropriate location in the step sequence.
Cautions:
•Before performing the procedures in this chapter, except for when
•Be aware when removing the memory box that removed parts are hot. Wait approximately 10 minutes after removing the parts before handling them.
•Wear cotton gloves when handling DIMM.
•Take measures against static.
1.Remove the memory box. For instructions, see “Removing a Memory Box” on page 45.
2.Push out on the clips at each end of the DIMM socket(s) to open them.
Note: It may be difficult to open the clips on the memory socket. Do not apply force to peripheral parts when opening the clips.
Caution: Be careful not to touch peripheral parts when opening the clips for the DIMM socket.
3. Pull the DIMM from the socket.
Caution: Be careful not to apply force to peripheral parts when removing a DIMM.
4.Install the memory box. For instructions, see “Installing a Memory Box” on page 43, beginning with step 6.
Note: The system will not boot if a memory box is installed with no DIMMs in it.
50 | Intel® Server System SR9000MK4U Product Guide |
