Siemens TC63 manual Atshup=?, ATSHUP=cause, cn, Causenum

TC63 AT Command Set

7.11 AT^SHUP

s

7.11 AT^SHUP Hang up call(s) indicating a specific GSM04.08 release cause

Syntax

Test Command

AT^SHUP=?

Response(s)

OK

Write Command

AT^SHUP=<cause>[, <cn>]

Response(s)

ERROR

OK

Reference(s)

Siemens

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

% % % % % % % ! ! !

Command Description

The write command serves to end one specific call or all calls known to the ME, indicating a specific GSM04.08 release cause specified by the user. The command can be used for voice, fax and data calls in any call status (i.e. any calls listed by AT+CLCC).

Parameter Description

<cause>(num)

release cause

Release cause from GSM04.08 to be indicated to the network.

The TC63 will release the selected connection(s) with release cause indication "cause" and location "user" (0) in the "disconnect" protocol message to the GSM Network. It depends on the network whether or not the release cause will be forwarded to the remote party.

1	send GSM04.08 release cause "unassigned (unallocated) number"
16	send GSM04.08 release cause "Normal call clearing "
17	send GSM04.08 release cause "User busy "
18	send GSM04.08 release cause "No user responding "
27	send GSM04.08 release cause "Destination out of order "
31	send GSM04.08 release cause "Normal, unspecified"

<cn>(num)

call number

The "call number" is an optional index into the list of current calls available via AT+CLCC. AT command AT^SHUP will terminate the call identified by the specified call number. The default call number "0" is not assigned to any call, but signifies "all calls". As "0" is the default value, it may be omitted.

With AT^SHUP, Calls will be terminated regardless of their current call status, which may be any of the states allowed by AT+CLCC.

[0]	terminate all known calls
1...7	terminate the specific call number <cn>

TC63_ATC_V00.490	Page 152 of 501	5/24/05
Confidential / Draft - Do not copy