TC63 AT Command Set

10.1 AT^SICS

s

 

uses dynamic DNS assignment. Any other address means that the Primary

 

DNS is manually set.

 

The default value applies automatically if no other address is set. Note that the

 

AT^SICS read command only returns a manually configured IP address, while

 

the value "0.0.0.0" is not indicated at all, no matter whether assumed by default

 

or explicitly specified.

“dns2“

Secondary DNS server address (IP address in dotted-four-byte format).

 

If "dns1" = "0.0.0.0" this setting will be ignored. Otherwise this value can be

 

used to manually configure an alternate server for the DNS1.

 

If "dns1" is not equal "0.0.0.0" and no "dns2" address is given, then

 

"dns2"="0.0.0.0" will be assumed automatically. The AT^SICS read command

 

only returns a manually configured IP address, while the value "0.0.0.0" is not

 

indicated at all, no matter whether assumed by default or explicitly specified.

<conParmValue>(str)

Parameter value; type and supported content depend on related <conParmTag>.

<conParmValue-conType>(str)

Supported connection type values in <conParmValue> for <conParmTag> value "conType".

“CSD“

Circuit-switched data call.

“GPRS0“

GPRS connection.

 

Settings of GPRS related commands are not used, e.g. AT+CGDCONT. When a

 

service based on a GPRS connection profile is started after entering AT^SISO

 

TC63 automatically tries to attach to the GPRS. Yet, the only exception is

 

AT+CGATT which can be used any time to detach from the GPRS and, and thus

 

disconnect the bearer opened with AT^SISO.

“none“

Clears the connection profile.

<conParmValue-alphabet>(str)

Character set selectable with <conParmValue> for <conParmTag> value "alphabet".

[“0“]

Character set determined with AT+CSCS applies.

“1“

International Reference Alphabet (IRA, seven bit ASCII) applies.

<conParmValue-dataRate>(str)

Supported data rate values in <conParmValue> for <conParmTag> value "dataRate".

“0“

14.4 KBaud

[“1“]

9.6 KBaud

<conParmValue-dataType>(str)

Supported data call type values in <conParmValue> for <conParmTag> value "dataType".

“0“

ISDN

[“1“]

Analog

TC63_ATC_V00.490

Page 239 of 501

5/24/05

Confidential / Draft - Do not copy

 

 

Page 239
Image 239
Siemens TC63 manual ConParmValuestr, ConParmValue-conTypestr, ConParmValue-alphabetstr, ConParmValue-dataRatestr