Siemens TC63 manual Gprs Commands, 11.1 AT+CGACT PDP context activate or deactivate, At+Cgact=?

TC63 AT Command Set

11. GPRS Commands

s

11.GPRS Commands

This chapter describes AT Commands that a TE (Terminal Equipment, e.g. an application running on a control- ling PC) may use to control the TC63 acting as GPRS Mobile Termination (MT). Please use chapter "Using GPRS AT commands (Examples)" as a first guidance.

11.1AT+CGACT PDP context activate or deactivate

Syntax

Test Command

AT+CGACT=?

Response(s)

+CGACT: (list of supported <state>s)

OK

Read Command

AT+CGACT?

Response(s)

+CGACT: <cid>, <state>

[+CGACT: <cid>, <state>]

...

OK

Write Command

AT+CGACT=[<state>[, <cid>[, <cid>]]]

Response(s)

OK ERROR +CME ERROR

Reference(s)

GSM 07.07

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

% % % % % % % ! ! !

Command Description

The test command is used for requesting information on the supported PDP context activation states. The read command returns the current activation states for all the defined PDP contexts.

The write command is used to activate or deactivate the specified PDP context(s). After the command has com- pleted, the MT remains in V.250 command state. If any PDP context is already in the requested state, the state for that context remains unchanged. If the MT is not GPRS attached when the activation form of the command is executed, the MT first performs a GPRS attach and then attempts to activate the specified contexts. If no <cid>s are specified the activation/deactivation form of the command activates/deactivates all defined contexts.

Parameter Description

<state>(num)

Indicates the state of PDP context activation.

0	deactivated
[1]	activated

TC63_ATC_V00.490	Page 268 of 501	5/24/05
Confidential / Draft - Do not copy