TC63 AT Command Set

18.15 AT^SNFS

s

18.15AT^SNFS Select audio hardware set

The AT^SNFS write command serves to set the audio mode required for the connected equipment.

AT^SNFS can also be used in conjunction with AT^SAIC. This is useful, for example, if the audio interfaces are operated alternatively to benefit from different devices. Each audio mode can be assigned a specific interface. To do so, first select the audio mode with AT^SNFS, then activate the audio interface with AT^SAIC and finally enter AT^SNFW to store the settings to your audio profile. To switch back and forth it is sufficient to use AT^SNFS.

Syntax

Test Command

AT^SNFS=?

Response(s)

^SNFS: (list of supported <audMode>s)

OK

Read Command

AT^SNFS?

Response(s)

^SNFS: <audMode>

OK

Write Command

AT^SNFS=<audMode>

Response(s)

OK

ERROR

CME ERROR: <err>

Reference(s)

SIEMENS

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

! % % % % % % ! % !

Parameter Description

<audMode>(num)(^SNFW)

[1]

Audio mode 1: Standard mode optimized for the reference handset, that can

 

 

be connected to the analog interface 1 (see "TC63 Hardware Interface

 

 

Description" for information on this handset.) To adjust the volume use the

 

 

knob of the reference handset. In audio mode 4, this handset can be used with

 

 

user defined parameters.

 

 

 

 

Note: The default parameters are determined for type approval and are not

 

 

adjustable with AT commands.

 

 

 

 

AT^SNFD restores <audMode> 1.

 

 

2

Audio mode 2: Customer specific mode for a basic handsfree (speakerphone)

 

 

device (Siemens Car Kit Portable).

 

 

 

 

Analog interface 2 is assumed as default.

 

 

3

Audio mode 3: Customer specific mode for a mono-headset.

 

 

 

 

Analog interface 2 is assumed as default.

 

 

4

Audio mode 4: Customer specific mode for a user handset.

 

 

 

 

Analog interface 1 is assumed as default.

 

 

5

Audio mode 5: Customer specific mode.

 

 

 

 

Analog interface 1 is assumed as default.

 

 

6

Audio mode 6: Customer specific mode.

 

 

 

 

Analog interface 2 is assumed as default.

 

 

 

 

 

 

 

TC63_ATC_V00.490

Page 428 of 501

5/24/05

Confidential / Draft - Do not copy

 

 

 

Page 428
Image 428
Siemens TC63 manual Atsnfs Select audio hardware set, Atsnfs=?, Atsnfs?