Siemens TC63 10 AT+CLIR Calling line identification restriction, At+Clir=?, At+Clir?, +CLIRn, m

[0](P)

1

2

TC63 AT Command Set

9.10 AT+CLIR

s

9.10AT+CLIR Calling line identification restriction

The AT+CLIR command refers to the GSM supplementary service CLIR (Calling Line Identification Restriction).

Syntax

Test Command

AT+CLIR=?

Response(s)

+CLIR: (list of supported <n>s)

OK

Read Command

AT+CLIR?

Response(s)

+CLIR<n>, <m>

OK ERROR

+CME ERROR: <err>

Write Command

AT+CLIR=[<n>]

Response(s)

OK ERROR

+CME ERROR: <err>

Reference(s)

GSM 07.07

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

% % % % % % % ! ! !

Parameter Description

<n>(num)

Parameter shows the settings for outgoing calls:

Presentation indicator is used according to the subscription of the CLIR service CLIR invocation

CLIR suppression

<m>(num)

Parameter shows the subscriber CLIR service status in the network:

0	CLIR not provisioned
1	CLIR provisioned in permanent mode
2	Unknown (e.g. no network, etc.)
3	CLIR temporary mode presentation restricted
4	CLIR temporary mode presentation allowed

Note

•The settings made with AT+CLIR=1 or AT+CLIR=2 are used for all outgoing calls until the ME is switched off or AT+CLIR=0 is used.

TC63_ATC_V00.490	Page 226 of 501	5/24/05
Confidential / Draft - Do not copy