Siemens TC63 manual EcATC at a given AutoExecIndex, AutoExecATC, Riod

TC63 AT Command Set

2.14 AT^SCFG

s

Parameter Description

<AutoExecCmd>(str)(+CSCS)

AutoExec Command

This parameter serves to switch the Autoexec function on or off.

If it is switched off (<AutoExecCmd>=0), parameters following <AutoExecIndex> are ignored and all settings at the given index are restored to their default values.

Value will be saved while switching off the TC63 via AT commands (e.g. AT+CFUN or AT^SMSO) and restored on next power up.

“0“	Disable automatic execution of the AT command(s) specified with <AutoEx-
	ecATC> at a given <AutoExecIndex>.
“1“	Enable automatic execution of the AT command(s) specified with <AutoExe-
	cATC> at a given <AutoExecIndex>. Not allowed for <AutoExecType>=0
	(DTR line activation) while multiplex mode is active, refer to AT+CMUX.
<AutoExecType>(str)(+CSCS)
AutoExec Event Type

This parameter selects the kind of event used to automatically launch the AT command(s) specified with

<AutoExecATC>.

Value will be saved while switching off the TC63 via AT commands (e.g. AT+CFUN or AT^SMSO) and restored on next power up.

“0“	Autoexec activity is driven by ASC0 DTR line activation (OFF-ON transition).
“1“	Autoexec activity is timer driven. To specify the time span use <AutoExecPe-
	riod>.
<AutoExecIndex>(str)(+CSCS)
AutoExec Command Index

This parameter specifies the command storage index. The following table shows the index ranges supported for each variant of <AutoExecType>.

Value will be saved while switching off the TC63 via AT commands (e.g. AT+CFUN or AT^SMSO) and restored on next power up.

<AutoExecType> value		<AutoExecType> event	Valid Indices
0		Autoexec activity is driven by ASC0 DTR	0
		line activation
1		Autoexec activity is timer driven.	0-2
<AutoExecMode>(str)(+CSCS)
AutoExec Command Mode
0...	255

This parameter specifies details regarding the behavior of the TC63 when the AT command starts to be exe- cuted.

Value is interpreted as a bit field, unused bits are reserved for future use (RFU) and shall be set to 0.

When a call is released by an Autoexec activity, no release indication may be issued on the first logical channel. If during a data call the TC63 temporarily enters command mode via +++ no AT command will be executed if <AutoExecMode> specifies 'Ignore ongoing calls'.

Value will be saved while switching off the TC63 via AT commands (e.g. AT+CFUN or AT^SMSO) and restored on next power up.

TC63_ATC_V00.490	Page 56 of 501	5/24/05
Confidential / Draft - Do not copy