Siemens TC63 Atmoni Monitor idle mode and dedicated mode, Atmoni=?, ATMONI=period, Periodnum

TC63 AT Command Set

8.8 AT^MONI

s

8.8AT^MONI Monitor idle mode and dedicated mode

The AT^MONI command supplies information of the serving/dedicated cell. There are two ways to retrieve the information: once on request by using the execute command or automatically every <period> seconds by using the write command. To stop the periodic presentation type "AT" or "at".

Syntax

Test Command

AT^MONI=?

Response(s)

^MONI:(list of supported <period>s)

OK

Exec Command

AT^MONI

Response(s)

See: Section 8.8.1, AT^MONI responses

OK

Write Command

AT^MONI=<period>

Response(s)

See: Section 8.8.1, AT^MONI responses

OK ERROR +CME ERROR

Reference(s)

SIEMENS

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

! % % % % % % ! ! !

Parameter Description

<period>(num)

Display period in seconds 1...254

Notes

•The two header lines (see Section 8.8.1, AT^MONI responses) are output after every ten data lines.

•The length of following output lines exceeds 80 characters. Therefore a terminal program may draw a carriage return on a screen. However, this is not part of the response.

•The parameters LAC and cell are presented as hexadecimal digits, the remaining parameters are composed of decimal digits.

•If the radio cell changes during a connection, the parameters PWR, RXLev and C1 of the 'Serving Cell' part cannot be updated under certain conditions and therefore, are displayed as "-" (for conditions see also AT+CREG). This is because the MS does not update the cell selection and reselection parameters since, in this mode, they are not relevant for operation. When the connection ends, and the mobile is back to IDLE mode, correct values will be given.

If the radio cell changes during a connection, it normally takes 1 or 2 seconds to update the parameters cell, NCC and BCC. Until the information is received from the new base station, the default values will be shown instead: cell="0000", NCC="-", BCC="-".

•If the BS supports frequency hopping during a connection, the dedicated channel (parameter chann) is not stable. This mode is indicated by chann = 'h'.

TC63_ATC_V00.490	Page 193 of 501	5/24/05
Confidential / Draft - Do not copy