Siemens TC63 AT+ICF Serial Interface Character Framing, At+Icf=?, At+Icf?, +ICF format, parity

TC63 AT Command Set

4.6 AT+ICF

s

4.6AT+ICF Serial Interface Character Framing

The command AT+ICF controls the serial interface character framing format and parity used for receiving and transmitting.

The following settings are supported:

•7 bits, even parity, 1 stop bit (AT+ICF=5,1)

•7 bits, odd parity, 1 stop bit (AT+ICF=5,0)

•8 bits, even parity, 1 stop bit (AT+ICF=2,1)

•8 bits, no parity, 1 stop bit (AT+ICF=3)

•8 bits, odd parity, 1 stop bit (AT+ICF=2,0)

•8 bits, no parity, 2 stop bits (AT+ICF=1)

Syntax

Test Command

AT+ICF=?

Response(s)

+ICF: (list of supported <format>s), (list of supported <parity>s)

OK

Read Command

AT+ICF?

Response(s)

+ICF: <format>[, <parity>]

OK

Write Command

AT+ICF=[<format>][, <parity>]

Response(s)

OK

ERROR

Reference(s)

V.250

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

! % % ! § § § ! % !

Parameter Description

<format>(num)(&W)(&V)

Specifies the character format used for receiving and transmitting.

1	8 data 0 parity 2 stop
2	8 data 1 parity 1 stop
[3]	8 data 0 parity 1 stop
5	7 data 1 parity 1 stop

<parity>(num)(&W)(&V)

Specifies the method of calculating the parity bit, if a parity bit is supported by <format>. If <format> does not support parity, this parameter has to be omitted.

0	odd
1	even

TC63_ATC_V00.490	Page 94 of 501	5/24/05
Confidential / Draft - Do not copy