Siemens TC63 +CBM sn, mid, dcs, page, pagesCRLFdata, +CDS lengthCRLFpdu, Ds=2 +CDSI mem3, index

TC63 AT Command Set

13.11 AT+CNMI

s

URC 5

<bm>=2 (text mode enabled):

+CBM: <sn>, <mid>, <dcs>, <page>, <pages><CR><LF><data>

Indicates that new cell broadcast message has been received

URC 6

<ds>=1 (PDU mode enabled):

+CDS: <length><CR><LF><pdu>

Indicates that new SMS status report has been received

URC 7

<ds>=1 (text mode enabled):

+CDS: <fo>, <mr>[, <ra>][, <tora>], <scts>, <dt>, <st>

Indicates that new SMS status report has been received

URC 8

<ds>=2:

+CDSI: <mem3>, <index>

Indicates that new SMS status report has been received

Command Description

The write command selects the procedure how the receipt of new SMS messages from the network is indicated to the TE when TE is active, e.g. DTR signal is ON. If TE is inactive (e.g. DTR signal is OFF), message receiving should be done as specified in GSM 03.38. If the DTR signal is not available or the state of the signal is ignored (V.250 command AT&D0, reliable message transfer can be assured by using AT+CNMA acknowledgment proce- dure. The rules <mt>=2 and <mt>=3 for storing received SM are possible only if phase 2+ compatibility is acti- vated with AT+CSMS=1. The parameter <ds>=1 is only available in phase 2+

Parameter Description

<mode>(num)(&W)

[0](&F)	Buffer unsolicited result codes in the TA. If TA result code buffer is full, indica-
	tions can be buffered in some other place or the oldest indications may be dis-
	carded and replaced with the new received indications.
1	Discard indication and reject new received message unsolicited result codes
	when TA-TE link is reserved (e.g. in on-line data mode). Otherwise forward
	them directly to the TE.
2	Buffer unsolicited result codes in the TA when TA-TE link is reserved (e.g. in
	on-line data mode) and flush them to the TE after reservation. Otherwise for-
	ward them directly to the TE.
3	Forward unsolicited result codes directly to the TE. TA-TE link specific inband
	technique used to embed result codes and data when TA is in on-line data
	mode.

<mt>(num)(&W)(&V)

Rules for storing received SMS depend on the relevant data coding method (refer to GSM 03.38), preferred memory storage (AT+CPMS) setting and this value.

Note: If AT command interface is acting as the only display device, the ME must support storage of class 0 mes- sages and messages in the message waiting indication group (discard message)

	[0](&F)	No SMS-DELIVER indications are routed to the TE.
1		If SMS-DELIVER is stored in ME/TA, indication of the memory location is
		routed to the TE using unsolicited result code:
TC63_ATC_V00.490		Page 338 of 501	5/24/05
Confidential / Draft - Do not copy