Siemens TC63 manual 18.4 AT+CLVL Loudspeaker volume level, At+Clvl=?, At+Clvl?, AT+CFUN=1,1

TC63 AT Command Set

18.4 AT+CLVL

s

18.4AT+CLVL Loudspeaker volume level

Syntax

Test Command

AT+CLVL=?

Response(s)

+CLVL: (list of supported<level>s)

OK

Read Command

AT+CLVL?

Response(s)

+CLVL: <level>

OK ERROR

+CME ERROR: <err>

Write Command

AT+CLVL=<level>

Response(s)

OK ERROR

+CME ERROR: <err>

Reference(s)

GSM 07.07

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

! % % % % % % ! % !

Parameter Description

<level>(num)

Loudspeaker Volume Level 0...4(D)

Notes

•The write command can only be used in audio mode 2 - 6.

•The values of the volume steps are specified with the parameters <outCalibrate>[0],...<outCali- brate>[4] of the AT^SNFO command.

•As an alternative to AT+CLVL, you can use AT^SNFO and AT^SNFV. The parameter <level> is identical with <outStep> used by both commands.

•Any change to <level> (or <outStep>) takes effect in audio modes 2 to 6. That is, when you change <level> (or <outStep>) and then select another mode with AT^SNFS, the same step will be applied. The only exception is audio mode 1 which is fixed to <level>=4 (or accordingly <outStep>=4).

•<level> (or <outStep>) is stored non-volatile when the ME is powered down with AT^SMSO or reset with

AT+CFUN=1,1.

TC63_ATC_V00.490	Page 413 of 501	5/24/05
Confidential / Draft - Do not copy