Siemens TC63 manual 11.20 ATH

TC63 AT Command Set

11.20 ATH

s

11.20 ATH Manual rejection of a network request for PDP context acti- vation

The V.250 ATH command may be used to deactivate all PDP contexts which are active or online on the same interface. This command should not be used to deactivate PDP contexts during the implicit PDP context deacti- vation procedure which is started automatically after LCP termination or by dropping the DTR line (if AT&D2 is configured). For details refer to Section 11.5.1, Automatic deactivation of PDP context during dial-up PPP.

The ATH command may also be used to reject a network request for PDP context activation announced by the unsolicited result codes "RING: GPRS" or "+CRING: GPRS".

Syntax

Exec Command

ATH

Response(s)

OK

Reference(s)

GSM 07.07

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

% % § % % § § ! ! !

Notes

•In contrast to GSM 07.07 it is possible to cancel a connection with ATH after a break. This is done for com- patibility reasons due to the "dial-up network" drivers of Microsoft Windows.

•ATH is used as a standard V.250 AT command, too.

•If ATH is used to reject a network request for PDP context activation, then other PDP contexts on the same interface which are active or online will not be deactivated.

TC63_ATC_V00.490	Page 306 of 501	5/24/05
Confidential / Draft - Do not copy